SOLUTION |
Under normal conditions,
finishes dry in 30-45 High humidity will extend these
dry times. |
Follow label instructions. Overuse
can leave .sticky residue. |
When dry, restorer/maintainer will
continue to soften finish if not burnished. |
Thoroughly rinse and neutralize
floor after stripping. Use neutral cleaner in proper
dilution. |
Measure carefully and follow label
directions. |
Finish may have been exposed
to prolonged heat or cold. Shake or stir before using.
|
Make sure to rinse floor
until pick-up water remains clear. When recoating,
make sure no cleaner residue remains on floor - rinse
with clean water to prevent problems. |
Apply thin coats and allow
each coat to dry before applying the next coat. |
|
SOLUTION |
Use the recommended pad
for a particular task, whether it be burnishing or
cleaning. |
Clean with a wire brush
or put pad in deep sink and spray off the build-up.
Hang up to dry. |